JavaScript is disabled. Because that a far better experience, please enable JavaScript in your browser prior to proceeding.

You are watching: 2007 honda cr v transmission fluid change

Hey everyone.I decision to change the transmission liquid in my 07 CR-V AWD because that the first time after ~ doing part research. Every little thing went fine it"s simply I drained about 3.5L of fluid when the business manual claims that I must only obtain 2.5L.I filled that up and ensure the the liquid is in between the 2 marks top top the dip stick. (see picture). That is between the two marks as soon as the engine is heat or cold.I examine my friend"s CRV 07 AWD and also his just touches the dipstick(doesn"t struggle the bottom mark on the dipstick) once the engine is cold.Do you males think my level is correct? Did i overfill it? room there any issues through it gift overfilled?Thanks!Sh0wn

As lengthy as you measured what came out and also replaced it through the exact same amount, you can"t go wrong. Sound good. Use DW-1?What go the old fluid look like? Mileage that was provided for?
I didn"t measure it exactly. I just filled it until I fight the note on the dipstick. 135,000 KM. The liquid was a little bit darker than the brand-new one. Ns think it"s the DW-1. I guess the question is: have to it be between the 2 dots when the engine is cold / warm? mine friend"s does not hit the bottom when it"s cold.
The owner"s manual indicates checking the level as soon as the CRV is top top level ground with engine shut off after one minute. The level must be in between the marks. Sounds like your good.
I can"t number out wherein to write-up a question. Probably someone can aid me out. My question is: ns am walking to shot and replace atf fluid on mine 2007 crv. I"ve been doing part research. Should I journey the car to heat up the fluid before draining?

I can"t number out where to post a question. Maybe someone can assist me out. My concern is: i am going to shot and change atf liquid on mine 2007 crv. I"ve to be doing some research. Have to I journey the automobile to warmth up the fluid before draining?
I additionally have a 2007 CRV and also I am around to adjust mine because that the an initial time. Has anyone pulled the infection cooler line to flush out the converter while an altering the fluid? ns am curious to recognize which is the outlet and also inlet lines. Thanks for the help.
I let ours 08 2wd run till thefan kicks on. Drain it and also fill with 3 qrts. Operation it it spins the pan kicks on. Add fifty percent of a qrt. Drain and fill take away 3.5 qrts ~ above ours.

See more: Answered: The Lowest Mass Stars Cannot Become Giants Because

I additionally have a 2007 CRV and I am about to readjust mine because that the first time. Has actually anyone pulled the transmission cooler heat to flush the end the converter while an altering the fluid? i am curious to recognize which is the outlet and inlet lines. Thanks for the help.
You have to look at the sticky keep in mind at the peak of this forum. You"ll see that Honda particularly recommends NOT making use of any kind of flushing system. And Google about for people"s endure with strength flushes. You"ll uncover lots of bad reports. I have actually one come share together well... I absorbed my Silverado to my neighborhood shop for part maintenance. Ns ask them to only drop the pan, clean that out, put the pan earlier and refill the fluid. Lock tried to offer me ~ above a flush, but I stated no and also that it would cause an ext problems than it solves. The course, they provided me the standard lines that "we perform it all the time", etc.. The tranny was fine prior to I took it in. As soon as I choose it up, it appears the tech didn"t read my instructions and also hooked it up to the strength flush. While lock didn"t charge me because that that, the transmission currently shifts really rough. The stupid flusher thrust all species of grime right into various valves, etc. I"m about to try some Lucas product that can help. If the gets much worse, I"ll need some infection work.