Check out basic to monitor step-by-step overview on exactly how to change your Ford F-150 or super Duty truck"s brake rotors.

You are watching: Ford f150 rear brake rotor removal


This article applies to the Ford F-150 (2004-2014) and also F-250 supervisor Duty (2005-2014).

Every once in a while that is nice to role out the device set, jack increase the truck, and do a little wrenching. Granted, not every one of us are grasp mechanics and cannot upgrade whole suspension on a Saturday afternoon. An easy job to perform on her own, with only a moderate understanding of lefty loosey righty tighty, is replacing your truck’s brake discs yourself. Instead of the bowl brakes is not just rewarding, however a money saving as well. Going every DYI is fun. However, some can prefer dropping your truck off at a mechanic just in case any problems arise.


Materials Needed10 mm (Rear), 13 mm (front), and also 18 mm (front) sockets.1/2 “ journey (for 18mm socket) and breaker bar3 pound rubber mallet18” pry barSteel and also brass cable brushes8” C-ClampWire

Step 1 - Prepare your truck

Raise your truck, secure it v jack stands, and remove her tires. You have the right to learn much more about exactly how to carry out that by visiting our short article "How to readjust a Tire" on this website. You have the right to learn an ext about changing the tires by visiting our post "How to readjust a Tire."

*

Figure 1. Raise your truck and also secure it.

Step 2 - eliminate the brake calipers

Use her socket to remove the 2 18 mm bolts. Then usage your pry bar to tenderness pry the calipers loose. Cave the caliper making use of a wire. Don’t allow it hang loose. As soon as caliper is off, the rotor should come off.

*
Figure 2. Caliper prior to removal.

*
Figure 3. Eliminate the brake calipers.

Step 3: location the brand-new rotor

Clean increase the hub through wire brush. Put a thin layer of grease ~ above the hub before placing the brand-new rotor. Install the new rotor on.

*
Figure 4. Install the new rotor.

Step 4 - placed the calipers back on

Clean caliper real estate with cable brush. Compress the caliper piston by utilizing your C-clamp. As soon as compressed, place the pads ~ above it. Reinstall the calipers and tighten the 18mm bolts. Then tighten the 13mm bolts.

*
Figure 5. Compress the piston by tightening the C-clamp ~ above it.

*
Figure 5. Download the calipers back.

See more: What Is The Charge Of Titanium Dioxide, Scientists Get Charged Up Over Titanium Dioxide

Step 5 - download the rest of the components

Put the wheel on, tighten the lug nuts, progressive the car, eliminate the jack stands, and also lower it. Pump the brake pedals a few times prior to driving.